This is an unedited manuscript accepted for publication and provided as an Article in Press for early access at the author’s request. The article will undergo copyediting, typesetting, and galley proof review before final publication. Please be aware that errors may be identified during production that could affect the content. All legal disclaimers of the journal apply.
Ayisha A. M. Arishi,
Khalid A. Alamry,
Mahmoud A. Hussein,
- PhD student, Department of Chemistry, Faculty of Science, King Abdulaziz University, Jeddah, , Saudi Arabia
- Professor, Department of Chemistry, Faculty of Science, King Abdulaziz University, Jeddah, , Saudi Arabia
- Professor, Department of Chemistry, Faculty of Science, King Abdulaziz University, Jeddah, , Saudi Arabia
Abstract
Benzoxazine monomer was synthesized via a Mannich condensation reaction from phenolic and amine precursors, followed by thermal curing to form a crosslinked polybenzoxazine network for advanced composite applications. Electromagnetic interference (EMI) shielding materials based on lightweight polymer nanocomposites have attracted significant attention for advanced electronic applications. In this study, benzoxazine/epoxy nanocomposites reinforced with graphene oxide (GO) and zinc oxide (ZnO) at loadings of 5 and 10 wt% were prepared and evaluated. Electrical conductivity measurements revealed a marked decrease in sheet resistance from 9.0 × 10⁷ Ω/sq for the pure matrix to 5.0 × 10⁴ Ω/sq for the GO 10 wt% composite, suggesting the formation of conductive pathways. In contrast, ZnO-filled composites showed only limited improvement in conductivity, consistent with their semiconducting nature. The EMI shielding effectiveness (SE) was investigated in the X-band frequency range (8–12 GHz) using a vector network analyzer. The GO 10 wt% composite achieved an average SE of approximately 19.6 dB, compared to ~16 dB and ~15 dB for GO 5 wt% and ZnO-based composites, respectively. Analysis of shielding components indicated that absorption (SEA) appears to be the dominant mechanism, while reflection (SER) remains relatively low. A practical EMF shielding test demonstrated a significant reduction in transmitted power density in the presence of the nanocomposites, supporting the trends observed in VNA measurements. However, these measurements are considered qualitative due to instrumental limitations. Overall, the results indicate that GO-reinforced benzoxazine/epoxy nanocomposites provide enhanced EMI shielding performance primarily governed by absorption mechanisms.
Keywords: Electromagnetic interference shielding, Benzoxazine/epoxy nanocomposites, Absorption-dominated shielding, Electrical conductivity, X-band
References
1. Wang Y, Zhao W, Tan L, et al. Review of polymer-based composites for electromagnetic shielding application. Molecules. 2023; 28(15): 5628.
2. Hareesh HMS, Joseph P, George S. Electromagnetic interference shielding: A comprehensive review of materials, mechanisms, and applications. Nanoscale Adv. 2025; 7: 4510–34p. doi:10.1039/d5na00240k.
3. Bheema RK, J G, Bhaskaran K, et al. A review on recent progress in polymer composites for effective electromagnetic interference shielding properties – structures, process, and sustainability approaches. Nanoscale Adv. 2024; 6(23): 5773–5802p. doi:10.1039/d4na00572d.
4. Chand K, Zhang X, Chen Y. Recent progress in MXene and graphene based nanocomposites for microwave absorption and electromagnetic interference shielding. Arab J Chem. 2022; 15(10): 104143. doi:10.1016/j.arabjc.2022.104143.
5. Agag T, Geiger S, Ishida H. Thermal properties enhancement of polybenzoxazines: The role of additional non-benzoxazine polymerizable groups. In: Ishida H, Agag T, editors. Handbook of Benzoxazine Resins. Amsterdam: Elsevier; 2011.
6. Trejo-Machin A, Puchot L, Verge P. Design and synthesis of bio-based benzoxazines. In: Yılmaz FS, editor. Paint and Coatings Industry. London: IntechOpen; 2018.
7. Necolau MI, Biru EI, Aldrigo M, et al. A ternary multiscale nanocomposite system based on functionalized graphene oxide, carbon fibers and bio-based polybenzoxazine for electromagnetic shielding. Mater Adv. 2025; 6: 8968–8987p. doi:10.1039/D5MA00343A.
8. Zhang S, Sun H, Lan T, et al. High electromagnetic interference shielding effectiveness achieved by multiple internal reflection and absorption in polybenzoxazine/graphene foams. J Appl Polym Sci. 2021; 138(44): 51318. doi:10.1002/app.51318.
9. Meng F, Ishida H, Liu X. Introduction of benzoxazine onto the graphene oxide surface by click chemistry and the properties of graphene oxide reinforced polybenzoxazine nanohybrids. RSC Adv. 2014; 4: 9471–5p. doi:10.1039/c3ra47345g.
10. Barani Z, Kargar F, Godziszewski K, et al. Graphene epoxy-based composites as efficient electromagnetic absorbers in the extremely high-frequency band. ACS Appl Mater Interfaces. 2020; 12(25): 28635–44p. doi:10.1021/acsami.0c06729.
11. Barani Z, Kargar F, Mohammadzadeh A, et al. Multifunctional graphene composites for electromagnetic shielding and thermal management at elevated temperatures. Adv Electron Mater. 2020; 6: 2000520. doi:10.1002/aelm.202000520.
12. Megahed ON, Abdelhamid MI, Elwassefy NA, et al. Synthesis, structural, and characterization of polymethylmethacrylate matrix−ZnO nanocomposite. Sci Rep. 2025; 15(1): 42912. doi:10.1038/s41598-025-27385-z.
13. Yan J, Jia H, Zhou L, et al. Tunable complex permittivity and strong microwave absorption properties of novel dielectric-conductive ZnO/C hybrid composite absorbents. Metals. 2023; 13(7): 1220. doi:10.3390/met13071220.
14. Tran TS, Xu L, Zetterlund PB, et al. Solution-processable polymer nanocomposites for electromagnetic interference shielding. Adv Mater Interfaces. 2025; 12(13): 2500225. doi:10.1002/admi.202500225.
15. Chhetri S, Kuila T. Polymer composites with 3D graphene architectures as high-performance EMI shielding materials: a review. RSC Appl Polym. 2024; 2(4): 507–33p. doi:10.1039/d4lp00061g.
16. Lochab B, Monisha M, Amarnath N, et al. Review on the accelerated and low-temperature polymerization of benzoxazine resins: Addition polymerizable sustainable polymers. Polymers. 2021; 13(8): 1260. doi:10.3390/polym13081260.
17. Ning X, Ishida H. Phenolic materials via ring-opening polymerization: Synthesis and characterization of bisphenol-A based benzoxazines and their polymers. J Polym Sci A Polym Chem. 1994; 32(6): 1121–9p. doi:10.1002/pola.1994.080320614.
18. Zhou Z, Si Q, Wan L, et al. Curing kinetics of main-chain benzoxazine polymers synthesized in continuous flow. Ind Eng Chem Res. 2022; 61(7): 2947–54p. doi:10.1021/acs.iecr.1c04771.
19. Petrakova VV, Kireev VV, Onuchin DV, et al. Benzoxazine monomers and polymers based on 3,3′-dichloro-4,4′-diaminodiphenylmethane: Synthesis and characterization. Polymers. 2021; 13(9): 1421. doi:10.3390/polym13091421.
20. Ribeiro FWM, Silva-Oliveira D, Cervi G, et al. Isomeric speciation of bisbenzoxazine intermediates by ion spectroscopy and ion mobility mass spectrometry. ACS Omega. 2024; 9(39): 40932–40p. doi:10.1021/acsomega.4c06205.
21. Jamrozik A, Barczewski M, Framski G, et al. Synthesis and characterization of low-cost cresol-based benzoxazine resins as potential binders in abrasive composites. Materials. 2020; 13(13): 2995. doi:10.3390/ma13132995.
22. Wang J, Liu Q, Yu J, et al. Synthesis and characterization of benzoxazine resin based on furfurylamine. Materials. 2022; 15(23): 8364. doi:10.3390/ma15238364.
23. Dumas L, Bonnaud L, Olivier M, et al. Multiscale benzoxazine composites: The role of pristine CNTs as efficient reinforcing agents for high-performance applications. Compos Part B Eng. 2017; 112: 57–65p. doi:10.1016/j.compositesb.2016.12.039.
24. Musa A, Alamry KA, Hussein MA. The effect of curing temperatures on the thermal behaviour of new polybenzoxazine-modified epoxy resin. Polym Bull. 2020; 77(10): 5439–49p. doi:10.1007/s00289-019-03026-0.
25.Ishida H, Allen DJ. Physical and mechanical characterization of near-zero shrinkage polybenzoxazines. J Polym Sci B Polym Phys. 1996; 34(6): 1019–30p. doi:10.1002/(SICI)1099-0488(19960430)34:63.0.CO;2-T.
26. Zhu C, Gao X, Fan W, et al. Synthesis, characterization, and properties of a novel aromatic ester-based polybenzoxazine. RSC Adv. 2020; 10(12): 6953–59p. doi:10.1039/C9RA10191H.
27. Assunção ICC, Sério S, Ferreira Q, et al. Graphene oxide layer-by-layer films for sensors and devices. Nanomaterials. 2021; 11(6): 1556. doi:10.3390/nano11061556.
28. Dimiev AM, Halbig CE, Talyzin A. A critical review to avoid common misinterpretations in characterizing graphene oxide. Chem Rev. 2026; 126(5): 3055–88p. doi:10.1021/acs.chemrev.5c00756.
29. Zhu S, Sun H, Liu X, et al. Room-temperature NH₃ sensing of graphene oxide film and its enhanced response on the laser-textured silicon. Sci Rep. 2017; 7(1): 14773. doi:10.1038/s41598-017-15270-3.
30. Takeichi T, Kano T, Agag T. Synthesis and thermal cure of high molecular weight polybenzoxazine precursors and the properties of the thermosets. Polymer. 2005; 46(26): 12172–80p. doi:10.1016/j.polymer.2005.10.088.
31. Bîru EI, Gârea SA, Nicolescu A, et al. Advanced polybenzoxazine structures based on modified reduced graphene oxide. Polymers. 2018; 10(9): 941. doi:10.3390/polym10090941.
32. Bîru I, Damian CM, Gârea SA, et al. Benzoxazine-functionalized graphene oxide for synthesis of new nanocomposites. Eur Polym J. 2016; 83: 244–55p. doi:10.1016/j.eurpolymj.2016.08.024.
33. Supreetha M, Veena MG, Madhukar BS, et al. Polycarbonate nanocomposite thin films for EMI shielding: influence of CeNiO₃ and graphene nanoplatelets. J Mater Sci Mater Eng. 2025; 20(1): 142. doi:10.1186/s40712-025-00361-1.
34. Zhang S, Wang Y, Ran Q, et al. Electromagnetic interference shielding property of polybenzoxazine/graphene/nickel composites. React Funct Polym. 2019; 143: 104324. doi:10.1016/j.reactfunctpolym.2019.104324.
35. Hu F, Zeng J, Li P, et al. Nacre-inspired strong nanopapers of aramid nanofiber-integrated montmorillonite nanoplates, cellulose nanofibrils, and Ag nanowires for high-performance electrical heaters. J Mater Chem A. 2023; 11(26): 14126–44p. doi:10.1039/D3TA02175K.
36. Lalan V, Narayanan AP, Surendran KP, et al. Room-temperature ferromagnetic Sr₃YCo₄O₁₀₊δ and carbon black-reinforced polyvinylidenefluoride composites toward high-performance electromagnetic interference shielding. ACS Omega. 2019; 4(5): 8196–206p. doi:10.1021/acsomega.9b00454.
37. Isari AA, Ghaffarkhah A, Hashemi SA, et al. Structural design for EMI shielding: From underlying mechanisms to common pitfalls. Adv Mater. 2024;36:2310683. doi:10.1002/adma.202310683.
38. Cheng J, Li C, Xiong Y, et al. Recent advances in design strategies and multifunctionality of flexible electromagnetic interference shielding materials. Nano-Micro Lett. 2022;14:80. doi:10.1007/s40820-022-00823-7.
39.Georgakilas V, Tiwari JN, Kemp KC, et al. Noncovalent functionalization of graphene and graphene oxide for energy materials, biosensing, catalytic, and biomedical applications. Chem Rev. 2016;116(9):5464–5519p. doi:10.1021/acs.chemrev.5b00620.
Journal of Polymer & Composites
| Volume | 14 | |
| 05 | ||
| Received | 10/09/2026 | |
| Accepted | 09/10/2026 | |
| Published | 16/10/2026 | |
| Publication Time | 36 Days |